![]() Incremental Assembly (-I, -incremental): Add a single device to an appropriate array.Grow (-G, -grow): Grow (or shrink) an array, or otherwise reshape it in some way.This is only meaningful for RAID1, 4, 5, 6, 10 or multipath arrays. Follow/Monitor (-F, -follow, -monitor): Monitor one or more md devices and act on any state changes.Create (-C, -create): Creates a new array with per-device metadata (superblocks).Build (-B, -build): Builds an array that doesn’t have per-device metadata (superblocks).Assemble (-A, -assemble): assembles the components of a previously created array into an active array.specifies any major mdadm operation mode which can be one of the following The basic command line syntax for mdadm commad is mdadm If not installed, you can install it by running the command below apt install mdadm mdadm is a utility that can be used to manage MD devices aka Linux Software RAID.Ĭheck if the package is installed. Now that we have two disks setup, you can now go ahead and setup software RAID on Ubuntu 20.04.īefore you can proceed, ensure that you have mdadm package installed. parted -a optimal /dev/sdc print Model: ATA VBOX HARDDISK (scsi)ġ 1049kB 4295MB 4294MB primary raid Setup Software RAID on Ubuntu 20.04 ![]() Number Start End Size Type File system Flags Sector size (logical/physical): 512B/512B parted -a optimal /dev/sdb print Model: ATA VBOX HARDDISK (scsi)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |